WATER COOLER SD5C BENCH TOP COOL & COLD AUTO FILL

✓The most reliable POU cooler on the market

✓Attaches directly to your water source

✓Large integral reservoir (12 litres)

✓Easily cleaned and sanitised

✓36 Month Comprehensive Warranty

GENERAL FEATURES

Our D5 series point of use (P.O.U.) Water centres provide a never ending supply of refreshing water. They attach directly to your water source. The large 12 litre reservoir makes it the ideal choice fast flow levers and high clearance recessed alcove make it easy to draw water.

SPECIFICATIONS: CABINET:

Top and front panels are moulded of UV treated ABS and side panels are zinc coated steel sheets covered in electrostatically applied high polymer polyester resin.

COLOUR:

High gloss cloud white available as standard.

DRIP TRAY:

Concealed lift-out design of a high impact durable plastic. Removable for sanitation, it incorporates an anti-splash grid which diverts drain water into the drip tray.

TAPS:

High impact polypropylene lever type. Fast flow and easy to operate. They’re assembled directly onto the reservoir and are fully recessed for added protection. Taps are 177mm above the drain grid allowing ample room for filling kettles and other tall objects.

TOP:

One piece heat resistant plastic. This rust-proof top provides a flat surface to hold small coffee servers and trays.

FUNCTION STATUS DISPLAY:

unique design. This exclusive device illuminates a red green signal indicating the Power/Hot/Cold position of the dispenser.

COOLING RESERVOIR:

Constructed of polypropylene plastic, approximately 12 litres in capacity. The reservoir features large radius corners to facilitate cleaning. The integrated zoned waterway and baffle system prevents ice rings from restricting chilled water flow. Cold water capacity below the baffle is 4.2 litres. Water above the baffle stays at or about room temperature.

AIR FILTER: Located on the float assembly for easy access. The air filter contains a replaceable filter disc with a one micron membrane media.

FLOAT ASSEMBLY:

One stage polyethylene float valve system incorporates a primary float valve which maintains the water level in the reservoir and shuts off when full.

REFRIGERATION SYSTEM: Ozone friendly HFC-134a refrigerant. Flow is controlled by capillary tube which has no moving parts. Condenser is air cooled static type for silent running. No fan assembly is required. Compressor is hermetically sealed, permanently lubricated and protected against motor overload.

ELECTRICAL:

240 Volts 50Hz single phase. A 1.5 metre house cable and 3 pin plug is supplied. Full load current is 1.5 amps.

POWER CONSUMPTION:

D5C : 0.25kwh/day & 7.5kwh/month

INSTALLATION:

A 350kPa pressure limiting valve must be installed with this product. Failure to fit a pressure limiting valve will void the warranty.

PERFORMANCE:

Tap 1 Outlet water 9DC approx

Tap 2 Outlet water 18DC approx

SD5C: 15kg 

CAPACITIES:

ROOM TEMP °C 21 - 27 - 32 150ML

CUPS/HR 10°C 44 - 32 - 18

LITRES/HR AT 10°C 4.2 - 3.1 - 1.8

OUR PLUMBED IN WATER COOLER COME WITH A DOUBLE SWING WATER FILTRATION

SO NOT JUST 1 WATER FILTRATION BUT 2...

​THAT'S "AWESOME"

DOUBLE SWING WATER FILTER COMES WITH 2 FILTERS

SWING FILTER SYSTEMS OPTIONS

SEDIMENT CARTRIDGE – F –PNP -10 - PHOS

Polypropylene pre filter for the removal of dirt sediment, rust and particles.

Flow rate 2L per minute

Filter replacement – 3650L or 6 months.

5 micron

Operating Temperatures: 4-40C

CARBON BLOCK – F-PNP-10 CARB – 5 MIC

Silver impregnated carbon block for chemical, taste and odour removal.

Flow rate 2L per minute Flow rate 2L per minute

Filter replacement – 3650L or 6 months. Whichever occurs first.

5 micron

Operating Temperatures: 4-40C

ULTRA CARBON BLOCK – F- PNP -10 CARB – 1 MIC

Silver impregnated carbon block for chemical, taste and odour removal.

Flow rate 2L per minute Flow rate 2L per minute

Filter replacement – 3650L or 6 months. Whichever occurs first.

1 Micron

Operating Temperatures: 4-40C

PHOSPHATE – F- PNP – 10 - PHOS

Removes scale build up in coffee machines, refrigerators, hot water boilers,

water cooler, etc

Granule activated carbon/phosphate

Flow rate 2L per minute

Filter replacement – 3650L or 6 months. Whichever occurs first.

Operating Temperatures: 4-40C

INSTALLATION INSTRUCTIONS

IF CHOOSING EZIDEBIT THIS FORM IS REQUIRED. (ONCE DEPOSIT HAS BEEN PAID THIS WILL BE DISPATCHED.)

PRICE INCLUDES DELIVERY COST OR PICK UP OUR SERVICE STATION SINGLETON.

D.I.Y. PRICE - RECOMMENDED PLUMBER INSTALL

SD5C MANUAL INFO