HOT POT EXTRAS + ALK STICK
OPTIONAL EXTRA FILTERS (1 = $50) (2 = $80) (3 = $110) (4 = $130)
1 X HOT POT -1 X ONE WAY VALUE - RETURN PIPE - BACK DRAIN PIPE.
POSSIBLE ISSUES:
1. Check to see if turned on (RED heat button)
2. Check your Hot temperature Settings (>92deg)
3. Motherboard could be burnt out
4. Kettle - hot pot temperature needs resetting
5. Kettle - hot pot element could have burned out
1. Check if turned ON
2. RED light triangle grids with hot flames
To turn on, push the Heat button once
Will only take 15 minutes to heats up.
3. Check your hot settings (>92 deg) max
CHECK MOTHERBOARD FOR ANY SIGNS OF DAMAGE
TURN POWER OFF BEFORE STARTING (BEST UNPLUGGED)
Unscrew 2 x screws located back of water cooler
Remove lid, wiggle to loosen
Remove Lid, making sure wires stay together
Unscrew metal box via 2 x screws at back of machine
IF NO box water cooler <2006 (rare parts)
Check signs of damage, burnt out via front, then check back for signs of damage too
Hot may be damaged but cold still ok.
IF Motherboard has signs of damage this needs to be replaced
OTHER ISSUES:
Check that the hot trip switch is NOT the cause of the problem
How to reset the hot trip switch
TURN POWER OFF & UNPLUG BEFORE STARTING
Removed lid
Remove 2 x screws at the front
Remove drip tray
Unscrew 2 x screws behind drip tray
Unhook the side panels.
Remove front face
Cut stay tie
Remove steel pipe to tap
Check and make sure power is turned off
Push the button, located near blue & black wires
Listen for a click when pushed.
This should now be reset.
IF not, issue is elsewhere
Place a stay tie on the metal pipe
Place rubber pipe onto metal pipe.
Tighten the stay tie
Close up water cooler in reverse order
Clip hooks back
Screws behind drip tray
Screws at front top
Screws at back top
FILL UP with water
DO NOT turn on until you have check to see if they if water flow from the HOT tap
OTHER ISSUE:
Kettle – Hot Pot has burnt out
If water is still not heating up, possible cause hot pot
element has burned out, if so this part needs replacing
